Tiba STEAM6007 Uživatelský manuál stáhnout pdf (Strana 32)

32

1

When installing next to wood furnaces,

for safety reasons, a heat-resistant and

heat-insulating insulation plate is to be

installed on site to the same height as

the appliance and a minimum of 30 cm

deep.

3

To secure at the top, 2 holes with ø 2.8

mm as stamped can be drilled (Detail

C).

Electrical connection/cable

The electrical connection must be carried

out by a licensed installer.

A type H05VV-F cable or a higher value must

be used as the power supply lead.

The installation must be carried out using a

cable with a plug or, for a domestic installa-

tion, a separator with a contact opening of at

least 3mm is required which also separates

all poles of the appliance from the mains in

accordance with NIN 2000.

For a direct connection a cable length of at

least 120 cm is required.

1. Connect terminal as shown in the con-

nection diagram.

Connection diagram 400V

Phase definitions:

L1, L2, L3 (or R, S, T)

2. Secure the cord grip.

1

In case of repair the appliance must

be switched off from the mains.

1 2 ... 27 28 29 30 31 32 33 34 35 36

Komentáře k této Příručce

Žádné komentáře